| | Re: mid-size pulley wheel ?
|
|
(...) There is also :- (URL) (21 years ago, 26-Nov-03, to lugnet.technic, lugnet.build)
|
|
| | Re: mid-size pulley wheel ?
|
|
(...) There is also the micromotor pulley nr. 2983, which does NOT have the groove centered. (21 years ago, 26-Nov-03, to lugnet.technic, lugnet.build)
|
|
| | mid-size pulley wheel ?
|
|
Does a part exist that would function as a mid-size pulley wheel for a rubber belt ? I can use a wedge-belt wheel (p/n 4185) for a large pulley and a half bush (p/n 4265) for a small pulley. I was looking for something between these two that has the (...) (21 years ago, 26-Nov-03, to lugnet.technic, lugnet.build)
|
|
| | Simulating pneumatic sequencers, was Re: Pneumatic Quadraped 242
|
|
(...) Hi Kevin and all, I wanted to experiment with your sequencers without fussing too much with time consuming building, so I used simulation... I used a free electronics simulator, CircuitMaker Student ((URL) Piston + switch are equivalent to an (...) (21 years ago, 26-Nov-03, to lugnet.technic, lugnet.robotics)
|
|
| | Re: lego plane... not yet
|
|
(...) I did buy the mars explorer, but I've not made a glider yet. (...) Kevin (21 years ago, 26-Nov-03, to lugnet.technic)
|
|
| | Re: New Years Resolution Runner
|
|
(...) Sounds like a fun challenge! I'm up for it. Good luck! Kevin (...) (21 years ago, 26-Nov-03, to lugnet.technic, FTX)
|
|
| | lego plane... not yet
|
|
hi i'm just curious if some of you guys is still working on this project pixel (21 years ago, 26-Nov-03, to lugnet.technic)
|
|
| | Re: JCB JS220 Excavator
|
|
(...) I recind my comment about you needing practice :-),wet sand is the worst type. (...) Thats an even better idea I might borrow (blatantly steal :-) it! Steve (21 years ago, 26-Nov-03, to lugnet.technic)
|
|
| | New Years Resolution Runner
|
|
hey guys, I know everyone loves making walking bots. Cudos to all the walker developers... take a bow. But I know that Kevin C. and I have on occasion talked about what it would take to make an actual running LEGO bot. Lets open up a discussion for (...) (21 years ago, 26-Nov-03, to lugnet.technic, FTX)
|
|
| | Re: JCB JS220 Excavator
|
|
(...) I'd agree with this, it is possible to control the pneumatic valves so that more or less air gets through them. Rather than the problem with pneumatics being of digital in nature, to my mind the biggest problem is their elastic or springy (...) (21 years ago, 25-Nov-03, to lugnet.technic)
|