| |
In lugnet.build, Brad Mittelstedt writes:
> The following work table was my Sundays project. For starters I use to build
> on a 3/8 inch 4x8 board layed across a printer stand and a old desk. To say
> the least it was very flimsy. After I started seeing the middle starting to
> sag in and having horrifing thoughts of 100,000 legos falling to the floor, I
> knew it needed to be upgraded.
Nice table Brad! I had an idea I might try if I ever make a work table, top
it with that non-skid foamy padding stuff. That way bricks don't go sliding
all over. It's a little pricey, and finding a big roll would be a chore, but
I think that would a neet addition.
nice job
out
tk
|
|
Message is in Reply To:
 | | Poor Mans Work Table
|
| The following work table was my Sundays project. For starters I use to build on a 3/8 inch 4x8 board layed across a printer stand and a old desk. To say the least it was very flimsy. After I started seeing the middle starting to sag in and having (...) (23 years ago, 13-May-02, to lugnet.build, lugnet.general, lugnet.storage, lugnet.space)
|
8 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
