 | | Re: Droopy Star Destroyer
|
|
(...) ABS plastic has "memory", so if you can heat it up to the right temperature range, it will relax back into its original shape without slagging. From our experience at work, you'd need to start around 150 degrees and gradually work upwards from (...) (21 years ago, 5-Sep-03, to lugnet.starwars)
|
| |
| | Re: Droopy Star Destroyer
|
|
(...) bend (...) If you did this enough times though, wouldn't the beam eventually fatigue and break? Or is ABS resilient to repeated stressing within a limited range of motion? (21 years ago, 5-Sep-03, to lugnet.starwars)
|
| |
| | Re: Droopy Star Destroyer
|
|
(...) No, eventually it might start to show stress, but it should last a lot longer than if you just set it on a table and leave it alone until pieces start popping off. The more often you flip it, the less stress the beams should experience, as (...) (21 years ago, 6-Sep-03, to lugnet.starwars)
|
| |
| | Re: Droopy Star Destroyer
|
|
(...) Seeing as this suggestion would require a substantial rebuild for each flip (the beams in question are buried deep within the triangular support frames), I think I'll stick with the original plan and continue with the Galactica, at least (...) (21 years ago, 8-Sep-03, to lugnet.starwars)
|
