Subject:
|
Re: Spybotics To RCX Comm
|
Newsgroups:
|
lugnet.robotics.spybotics
|
Date:
|
Thu, 29 Aug 2002 18:06:09 GMT
|
Viewed:
|
4960 times
|
| |
|
|
Yes, I use NQC and BricxCC to program it. It's very simple, and I just set motor port C to forward
Steve
----- Original Message -----
From: "Dean Husby" <nntp@akasa.bc.ca>
Date: Thu, 29 Aug 2002 17:27:17 GMT
To: lugnet.robotics.spybotics@lugnet.com
Subject: Re: Spybotics To RCX Comm
"Steve Hassenplug" <hassenplug@mail.com> wrote in message
news:20020829163440.27793.qmail@verizonmail.com...
> I'm not sure if I'm setting it incorrectly, but it seems like the 'laser'
on the spybot (motor out C) flickers, which is really bad when you're
reading the light sensor.
I haven't tried this on the Spybot yet, (Waiting for NQC) but on the scout
you just set it to on like it was the 3rd motor port. And it stayed on.
There must be a way to do the same.
Are you using NQC or what? to program it?
Dean
--
_______________________________________________
Talk More, Pay Less with Net2Phone Direct(R), up to 1500 minutes free!
http://www.net2phone.com/cgi-bin/link.cgi?143
|
|
Message has 2 Replies:
 | | Re: Spybotics To RCX Comm
|
| "Steve Hassenplug" <hassenplug@mail.com> wrote in message news:20020829180609....ail.com... (...) set motor port C to forward So you got it to stay on for the Spybot? If so, I'm glad I could be of help. Dean (22 years ago, 29-Aug-02, to lugnet.robotics.spybotics)
| | | Re: Spybotics To RCX Comm
|
| (...) That is not the way to simply turn on the laser LED. When you set motor C to forward the LED will commence sending VLL motor forward commands out the LED which, of course, will result in a flickering LED. The Scout worked the same way - the (...) (22 years ago, 29-Aug-02, to lugnet.robotics.spybotics)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
