|
In lugnet.robotics, John Hansen wrote:
> I've released version 3.3.7.7 of BricxCC today.
Unfortunately, BricxCC is still not downloading the brickOS firmware correctly.
I will look into this problem and try to fix it. In the mean time, you can use
firmdl3 which works correctly.
John Hansen
|
|
Message has 1 Reply:
Message is in Reply To:
3 Messages in This Thread: ![BricxCC release 3.3.7.7 -John Hansen (22-Jan-04 to lugnet.robotics, lugnet.robotics.rcx, lugnet.robotics.rcx.legos, lugnet.robotics.rcx.nqc, lugnet.robotics.spybotics)](/news/x.gif) ![](/news/46.gif) ![You are here](/news/here.gif) ![](/news/46.gif) ![Re: BricxCC release 3.3.7.7 -John Hansen (30-Jan-04 to lugnet.robotics, lugnet.robotics.rcx, lugnet.robotics.rcx.legos, lugnet.robotics.rcx.nqc, lugnet.robotics.spybotics)](/news/x.gif)
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|