 | | printing on more than one page
|
|
I'm using ROBOLAB 1.5 on MacOS 9, using it to teach undergrad and grad students in design about interactive behaviors. I'd like to create printouts of some sample programs I have developed. I have not been able to figure out a way to get a large (...) (25 years ago, 14-Feb-00, to lugnet.robotics.rcx.robolab)
|
| |
| | Re: printing on more than one page
|
|
(...) students (...) on (...) I have not found any Robolab solution to printing large programs. Robolab 2.0 has not changed this annoying limitation. I use screen print programs to print Robolab programs, which is not very convenient. (25 years ago, 24-Feb-00, to lugnet.robotics.rcx.robolab)
|
| |
| | Re: printing on more than one page
|
|
have you tried doing a screen capture and then printing it from a different application. not the prettiest solution, but... -Ben (...) (25 years ago, 21-Mar-00, to lugnet.robotics.rcx.robolab)
|
| |
| | Re: printing on more than one page
|
|
(...) But that will only capture the visible portion of the program in the window. So I'd have to scroll the window around to do multiple captures to get all of the portions, and then paste them back together in PhotoShop to print them. If that's (...) (25 years ago, 21-Mar-00, to lugnet.robotics.rcx.robolab)
|
| |
| | Re: printing on more than one page
|
|
The icons in Robolab have the program logic flow from left to right, with modifiers below each icon. This basic structure typically creates programs that are very wide, but not very long. If Robolab were changed so the icons would have program flow (...) (24 years ago, 27-Mar-00, to lugnet.robotics.rcx.robolab)
|
