To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.rcx.robolabOpen lugnet.robotics.rcx.robolab in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / RCX / ROBOLAB / 131
  visible terminals and stringing modifiers
 
In RoboLab: How do you string one or more modifiers to a command? Why make the terminals visible on a command icon? Thanks for any assistance that you can offer. Sounds basic, but even our best stumbling and wild clicking did not trip across the (...) (23 years ago, 31-Oct-01, to lugnet.robotics.rcx.robolab, lugnet.dacta)
 
  Re: visible terminals and stringing modifiers
 
You use the wiring tool. For some tutorials on using Robolab visit: (...) (23 years ago, 1-Nov-01, to lugnet.robotics.rcx.robolab, lugnet.dacta)
 
  Re: visible terminals and stringing modifiers
 
(...) Yes, but at screen size 640x480. Earlier, we had not changed from our usual screen size 800x600. Your reply encouraged us to try again many times until it eventually worked, but not every time. We also had trouble with context help not always (...) (23 years ago, 1-Nov-01, to lugnet.robotics.rcx.robolab, lugnet.dacta)
 
  Re: visible terminals and stringing modifiers
 
I actually use a resolution of 1024 by 768 and its works fine. I do find sometimes there is a delay in the context help changing with the cursor. (...) (23 years ago, 2-Nov-01, to lugnet.robotics.rcx.robolab, lugnet.dacta)
 
  Re: visible terminals and stringing modifiers
 
(...) Robolab 2.5 makes wiring even easier with auto-wire. If you place an icon close enough to the END on the right side of an icon, the new icon will be automatically wired in. This also applies to modifiers. If a modifier is placed closely to the (...) (23 years ago, 5-Nov-01, to lugnet.robotics.rcx.robolab, lugnet.dacta)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR