 | | issues with 6-legs bot
|
|
Hi, I built this 6-legs bug for a black line tracking test. The construction: It is a walker with 2 motors, one for 3-left-legs, another one for the right. Middle leg on each side is connected on an 8-tooth gear and attach an 40-tooth gear. This (...) (22 years ago, 19-May-04, to lugnet.robotics.rcx.legos, lugnet.robotics.rcx.robolab)
|
| |
| | Re: Robolab Conference
|
|
(...) Very cool! As a LabVIEW programmer, I'm usually able to attend NIWeek. This year I'll definitely extend my stay. For those of you that are going to attend this conference, I'd highly recommend sticking around for NIWeek as well: (URL) is (...) (22 years ago, 8-May-04, to lugnet.robotics, lugnet.robotics.rcx.robolab)
|
| |
| | Re: Can Robolab stop the RCX switching off?
|
|
(...) This *trick* is in fact documented on page 13 of the "Getting Started" Teacher's Guide for ROBOLAB Software where it says "A setting of 0 means the RCX always stays on". The sematics is likely to cause confusion because earlier on it says (...) (22 years ago, 4-May-04, to lugnet.robotics.rcx.robolab)
|
| |
| | Re: Can Robolab stop the RCX switching off?
|
|
(...) I know nothing about Robolab, but you might wanna try setting this value to 0. ROSCO (22 years ago, 2-May-04, to lugnet.robotics.rcx.robolab)
|
| |
| | Re: Can Robolab stop the RCX switching off?
|
|
(...) Entering a value of 0 is the trick to disabling the powerdown. (22 years ago, 2-May-04, to lugnet.robotics.rcx.robolab)
|
