Subject:
|
RE: Loading firmware
|
Newsgroups:
|
lugnet.robotics.rcx.pbforth
|
Date:
|
Tue, 3 Sep 2002 00:16:14 GMT
|
Reply-To:
|
<RHEMPEL@BMTS.stopspammersCOM>
|
Viewed:
|
2628 times
|
| |
|
|
If you;ve got the most recent versions of pbForth, and you have Active Tcl
installed, then click on the rcxtk.tcl file and the pbForth console should
be launched immediately.
At that point, you can upload the pbForth.srec file using the pbForth/Upload
menu selection.
I'm assuming you are running on Windows, and have set COM1 for your serial port.
Do you have any programming experience with Forth?
Cheers, Ralph
> -----Original Message-----
> From: news-gateway@lugnet.com [mailto:news-gateway@lugnet.com]On Behalf
> Of Bruce Keltz
> Sent: Monday, September 02, 2002 6:28 PM
> To: lugnet.robotics.rcx.pbforth@lugnet.com
> Subject: Loading firmware
>
>
> I am a newbie to RIS 1.0 and would like to install pbforth as my firmware
> and then use it as my command(programming) language. How do I get started. I
> have downloaded the Active State Tcl ,rcxtel, and nqc to my computer. Where
> do I go from here ?
> BDK
>
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Loading firmware
|
| I am a newbie to RIS 1.0 and would like to install pbforth as my firmware and then use it as my command(programming) language. How do I get started. I have downloaded the Active State Tcl ,rcxtel, and nqc to my computer. Where do I go from here ? (...) (22 years ago, 2-Sep-02, to lugnet.robotics.rcx.pbforth)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
