To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.rcx.pbforthOpen lugnet.robotics.rcx.pbforth in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / RCX / pbFORTH / 517
516  |  518
Subject: 
Re: pbForth vs RCX 1.0
Newsgroups: 
lugnet.robotics.rcx.pbforth
Date: 
Thu, 27 Jun 2002 08:34:46 GMT
Viewed: 
5991 times
  
"Mario Beaulieu" <mariobeaulieu@videotron.ca> writes...
> Hi,
> 
> Is pbForth fully compatible with RCX 1.0?

Yes. I run pbForth on RCX 1.0, 1.5 and 2.0. No differences.

> Can RCX 2.0 communicate with RCX
> 1.0 in pbForth (using IR ports)?

No, to my knowledge. In pbForth the IR port is entirely devoted to
communication between the brick and the terminal. There are no words to
send/receive data through the IR port. That would be quite a nice addition,
but I wonder if it is possible.

Mario



Message has 1 Reply:
  Re: pbForth vs RCX 1.0
 
Thanks, Just to make sure, let's take an example. Let's say that I have two RCX, named A and B. What if the program in RCX B is waiting for a character on the instruction KEY and RCX A sends a character, let's say '5' (ASCII 52) with 52 EMIT ? That (...) (24 years ago, 27-Jun-02, to lugnet.robotics.rcx.pbforth)

Message is in Reply To:
  pbForth vs RCX 1.0
 
Hi, Is pbForth fully compatible with RCX 1.0? Can RCX 2.0 communicate with RCX 1.0 in pbForth (using IR ports)? Thanks Mario (24 years ago, 26-Jun-02, to lugnet.robotics.rcx.pbforth)

4 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR