Subject:
|
Installation of pbForth 1.11 Problems
|
Newsgroups:
|
lugnet.robotics.rcx.pbforth
|
Date:
|
Wed, 29 Dec 1999 16:36:04 GMT
|
Viewed:
|
1735 times
|
| |
|
|
Last night I tried to install pbForth 1.11 with nqc (2.02). It beeped like it
was installed and "4th" was displayed on the screen, but I could not turn it
off. I had to take out the batteries to get it to turn off, but by then, the
pbForth was gone. I could talk to it with a terminal program(HEX<CR>,
RCX_INIT<CR>, etc.), but all it gave me was "? Undefined Word".
I tried both the pbforth.srec and pbmax.srec from pbforth111.zip. Here is a
print out of them (Note: I'm using FreeBSD 4.0-CURRENT for this)...
p:patrick# nqc -firmware pbforth.srec
Downloading firmware:.........................................................
No reply from RCX
p:patrick# ls
pbforth.srec pbmax.srec scripts sources
p:patrick# ls -Al
total 67
-rw-r--r-- 1 patrick wheel 28980 Dec 20 12:54 pbforth.srec
-rw-r--r-- 1 patrick wheel 36864 Dec 20 12:54 pbmax.srec
drwxr-xr-x 2 patrick wheel 1024 Dec 28 23:32 scripts
drwxr-xr-x 2 patrick wheel 512 Dec 27 22:47 sources
p:patrick# nqc -firmware pbmax.srec
Downloading
firmware:.......................................................................
.
No reply from RCX
The "No reply from RCX" doesn't bother me much, since I get the same response
when I install the Lego firmware with nqc:
p:patrick# nqc -firmware Firm0309.lgo
Downloading
firmware:......................................................................
...........
No reply from RCX
Given all that information, is this normal? Or did I get a bad image?
Thoughts? Ideas?
Patrick
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
