|
|
 | | Re: Getting started; FFT; millisecond timing
|
| (...) Thanks, Patrick. I just took the plunge into pbForth and I was stuck. After downloading the firmware, I couldn't get Ralph's console nor Hyperterminal to give me an "OK" response. I couldn't figure out how to get to the Bricxcc pbForth (...) (20 years ago, 10-Oct-04, to lugnet.robotics.rcx.pbforth)
| | | | | RE: Pbforth probs
|
| Did you upload the pbforth_servo.srec file? (...) (20 years ago, 22-Jul-04, to lugnet.robotics.rcx.pbforth)
| | | | | Re: Pbforth probs
|
| (...) The fact is that nothing happens! Servo doesn't move (the interface works well with NQC) Or the console says "ABORTED etc..." What's wrong? (20 years ago, 22-Jul-04, to lugnet.robotics.rcx.pbforth)
| | | | | RE: Pbforth probs
|
| Sorry, the page IS unclear. 0 1 0 SERVO_SET will center the servo on the first motor port 50 1 0 SERVO SET wil moove it in one direction 100 1 0 SERVO_SET will move it more in one direction -50 1 0 SERVO_SET will move it in the other direction -100 (...) (20 years ago, 22-Jul-04, to lugnet.robotics.rcx.pbforth)
| | | | | Pbforth probs
|
| Hi. After reading the web pages, word lists, help, tutorials, I still wonder how to control SERVO MOTORS with PBForth. I tried the SERVO_SET command but it says "ABORTED (missing ;?)" What does it mean?How can I interprete the syntax explained on (...) (20 years ago, 22-Jul-04, to lugnet.robotics.rcx.pbforth)
|
|
