To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.rcx.pbforthOpen lugnet.robotics.rcx.pbforth in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / RCX / pbFORTH / 631
630  |  632
Subject: 
Re: Pbforth probs
Newsgroups: 
lugnet.robotics.rcx.pbforth
Date: 
Thu, 22 Jul 2004 15:49:00 GMT
Viewed: 
7909 times
  
In lugnet.robotics.rcx.pbforth, Ralph Hempel wrote:
> Sorry, the page IS unclear.
> 
> 0 1 0  SERVO_SET will center the servo on the first motor port
> 
>  50 1 0 SERVO SET wil moove it in one direction
> 100 1 0 SERVO_SET will move it more in one direction
> 
>  -50 1 0 SERVO_SET will move it in the other direction
> -100 1 0 SERVO_SET will move it more in the other direction
> 
> Hope this helps.


The fact is that nothing happens!
Servo doesn't move (the interface works well with NQC)
Or the console says "ABORTED etc..."
What's wrong?



Message has 1 Reply:
  RE: Pbforth probs
 
Did you upload the pbforth_servo.srec file? (...) (22 years ago, 22-Jul-04, to lugnet.robotics.rcx.pbforth)

Message is in Reply To:
  RE: Pbforth probs
 
Sorry, the page IS unclear. 0 1 0 SERVO_SET will center the servo on the first motor port 50 1 0 SERVO SET wil moove it in one direction 100 1 0 SERVO_SET will move it more in one direction -50 1 0 SERVO_SET will move it in the other direction -100 (...) (22 years ago, 22-Jul-04, to lugnet.robotics.rcx.pbforth)

4 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR