|
| | Re: Firmware loading failure
|
| I am able to download using native NQC - so NQC CC was the problem. (...) (24 years ago, 16-Jan-01, to lugnet.robotics.rcx.pbforth)
| | | | Firmware loading failure
|
| I have a repeating failure trying to download the firmware. I'm using RCX Command Center and pbforth 121. It fails in exactly the same spot - record 1638 - each and every time, with two different RCX units. The batteries are new and I can reload the (...) (24 years ago, 16-Jan-01, to lugnet.robotics.rcx.pbforth)
| | | | Re: Long range IR mode
|
| (...) Disclaimer: I didn't try ANYTHING of this... According to Kekoa's Internals, the ROM routine 0x3250 (0x3266) with parameter 0x1770 sets the IR range to long (short). So you need to do something like: push 0x1770 jsr 0x3250 pop ; Stack should (...) (24 years ago, 27-Dec-00, to lugnet.robotics.rcx.pbforth)
| | | | Long range IR mode
|
| I've discovered the RCX is in long range mode UNTIL I send it a POWER_INIT pbForth command. Pity... what's the way around this, anyone ? (24 years ago, 27-Dec-00, to lugnet.robotics.rcx.pbforth)
| | | | transmission distances
|
| When I muck about with Exploration Mars software, the RCX doesn't go out of range until it's out of the room. With pbForth, the RCX receives the commands over just as far a range, but can only send its "ok" feedback when it is quite close to the (...) (24 years ago, 19-Dec-00, to lugnet.robotics.rcx.pbforth)
| |