|
|
 | | Connecting 2 RCXs
|
| The IR interface is one way to establish a "connection" via messages between 2 RCXs and it works fine if both of the RCXs will receive a message - directly or by multiple reflections within the room. However, it is a slow communication. My problem (...) (24 years ago, 19-Oct-00, to lugnet.robotics.rcx.nqc)
| | | | | Re: Vision Command
|
| No. There isn't any. You cannot control the camera form NQC or the RCX for that matter. You can respond to the messages that the Camera sends to the brick via Message(). I hope this syntax is right.... until(Message)>0); switch(Message()) case 1: // (...) (24 years ago, 18-Oct-00, to lugnet.robotics.rcx.nqc)
| | | | | Vision Command
|
| Is there syntax that I am missing to address the "Vision Command" camera? Thanx! Ed (24 years ago, 18-Oct-00, to lugnet.robotics.rcx.nqc)
| | | | | "True" Interrupts
|
| When I did some work with the new control structures, I found out that they are quite nice (monitor and acquire). However, you could do the same in the past but you needed to split your program into several tasks which are controlled of a task (...) (24 years ago, 11-Oct-00, to lugnet.robotics.rcx.nqc)
| | | | | Re: The Datalog
|
| (...) That's why my post ended on a positive note. It's not that I'm ungrateful. Without Lego I wouldn't have hundreds of thousands of bricks all over my house... heh heh. I also wouldn't have 3 RCX's, a Scout & a Micro Scout. Lego just moves very (...) (24 years ago, 11-Oct-00, to lugnet.robotics.rcx.nqc)
|
|
