Subject:
|
Re: Thoughts & Issues w/ Vision Command
|
Newsgroups:
|
lugnet.robotics.rcx.nqc
|
Date:
|
Sat, 9 Sep 2000 00:40:43 GMT
|
Viewed:
|
2004 times
|
| |
|
|
Tim Goodwin wrote:
> Hello
>
> Does the Vision Command camera send messages to the RCX via the IR port ? I
> would assume this would be the case but I just wanted to make sure.
>
> Also, does Vision Command come pre-configured with a default program or do you
> have to configure it from scratch ? I'm trying to figure out how to get this to
> run with the RCX without buying a pc.
>
> How long will a configuration remain in the cameras memory ? Is it subject to
> the same "rules" as the RCX where this is concerbned or is it more/less volitile
> ?
>
> Finally, would anyone know how I might obtain a manual without buying the kit?
>
> Thanks
> Tim Goodwin
It MUST be used with a PC. The camera has no special programs or anything like that.
It's the PC that is the link between the Camera and the RCX...
Dean
--
Coin-Op's For Sale!: http://www.akasa.bc.ca/tfm/coin-op.html
Dean's Lego Workshop: http://www.akasa.bc.ca/tfm/lego_wr.html
Vancouver Lego Club: http://www.akasa.bc.ca/vlc
|
|
Message is in Reply To:
 | | Thoughts & Issues w/ Vision Command
|
| Hello Does the Vision Command camera send messages to the RCX via the IR port ? I would assume this would be the case but I just wanted to make sure. Also, does Vision Command come pre-configured with a default program or do you have to configure it (...) (24 years ago, 8-Sep-00, to lugnet.robotics.rcx.nqc)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
