Subject:
|
Thoughts & Issues w/ Vision Command
|
Newsgroups:
|
lugnet.robotics.rcx.nqc
|
Date:
|
Fri, 8 Sep 2000 00:12:19 GMT
|
Viewed:
|
1966 times
|
| |
|
|
Hello
Does the Vision Command camera send messages to the RCX via the IR port ? I
would assume this would be the case but I just wanted to make sure.
Also, does Vision Command come pre-configured with a default program or do you
have to configure it from scratch ? I'm trying to figure out how to get this to
run with the RCX without buying a pc.
How long will a configuration remain in the cameras memory ? Is it subject to
the same "rules" as the RCX where this is concerbned or is it more/less volitile
?
Finally, would anyone know how I might obtain a manual without buying the kit?
Thanks
Tim Goodwin
|
|
Message has 1 Reply:
 | | Re: Thoughts & Issues w/ Vision Command
|
| (...) It MUST be used with a PC. The camera has no special programs or anything like that. It's the PC that is the link between the Camera and the RCX... Dean -- Coin-Op's For Sale!: (URL) Lego Workshop: (URL) Lego Club: (URL) (24 years ago, 9-Sep-00, to lugnet.robotics.rcx.nqc)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
