Subject:
|
Re: Vision Command on a Mac
|
Newsgroups:
|
lugnet.robotics.rcx.nqc
|
Date:
|
Fri, 25 Aug 2000 22:45:15 GMT
|
Viewed:
|
2047 times
|
| |
|
|
In article <Fzv9ru.Fq1@lugnet.com>, Tim Goodwin <tgvoz@tidalwave.net> wrote:
> I there any way of getting this up and running on an old Mac with serial ports ?
No chance. The camera is USB.
--
Chris Osborn Full System, Inc.
fozztexx@fullsystem.com 2160 Jefferson St., #240
http://www.fullsystem.com/ Napa, CA 94559
Webhosting that *works* - 99.99% uptime - First 3 months free
|
|
Message has 1 Reply:
 | | Re: Vision Command on a Mac
|
| (...) If the mac has pci slots you can install a USB card. this , of course doesnt mean the software will work but you can add USB ports to "some" older macs. I am using a usb/firewire orange micro card in my 7500 power mac ( requires OS 8.6 or (...) (24 years ago, 26-Aug-00, to lugnet.robotics.rcx.nqc)
|
Message is in Reply To:
| | Vision Command on a Mac
|
| I there any way of getting this up and running on an old Mac with serial ports ? For months now I have been trying to figure out a way to accomplish what Vision Command does using third party hardware & software but haven't been very successful. Any (...) (24 years ago, 25-Aug-00, to lugnet.robotics.rcx.nqc)
|
5 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
