 | | Re: Curious problem with download
|
|
(...) downloading (...) I don't see any strange behaviour here; the hinky USB-to-serial interface is going to be your culprit. I had no problems using NQC on my PowerCenterPro (PowerComputing Macintosh clone) with a direct serial interface, but when (...) (25 years ago, 28-Jan-00, to lugnet.robotics.rcx.nqc)
|
| |
| | Curious problem with download
|
|
I just got Mindstorm set, and since I do not have a PC, NQC seemed like a great place to start. I tried Mac NQC and did not get very far downloading the RCX firmware. Every attempt resulted in the IR tower not seeing the RCX. I have a G3 blue and (...) (25 years ago, 27-Jan-00, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: opposite of float command for nqc ?
|
|
Thanx. That solved my problem. (...) including a (...) directions (...) drives. (...) used (...) where (...) (25 years ago, 27-Jan-00, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: opposite of float command for nqc ?
|
|
In NCQ & RCX Code, "Off" is the closest one gets to "locking" a motor. It will resist being turned, but in a crane application I can envision enough force to externally turn the shaft. You can prevet this from happening by including a worm gear in (...) (25 years ago, 27-Jan-00, to lugnet.robotics.rcx.nqc)
|
| |
| | opposite of float command for nqc ?
|
|
is there a command for ncq the lock a motor in place, sorta opposite to the float command? I have a arm that i have made and it sits sorta like a crane with a motor to rotate it up and down. Problem is i need it to stop at the bottom to pick an (...) (25 years ago, 27-Jan-00, to lugnet.robotics.rcx.nqc)
|
