 | | RE: Motor Speed Control —Steve Hassenplug
| | | | (...) :) (...) I'm not sure how the Swan firmware does it, but I have mine set so it cycles every 8 ms. It's on for 0 to 8 ms, then off (brake) for the rest, depending on the speed. That's fast enough to produce a very smooth result. There is no (...) (20 years ago, 30-Nov-04, to lugnet.robotics.rcx.nqc)
| | | | | | | | | | Re: Motor Speed Control —Philippe Hurbain
| | | | | (...) That's the case too for Swan firmware with standard parameters. (...) And yes, power consumption is much higher using on break. I measured variation of RCX current with one motor, power level 3 (50% duty cycle). Idle RCX current (35mA) is (...) (20 years ago, 1-Dec-04, to lugnet.robotics.rcx.nqc)
| | | | | | |
