Subject:
|
Re: problems with nqc under linux
|
Newsgroups:
|
lugnet.robotics.rcx.nqc
|
Date:
|
Fri, 17 Aug 2001 10:21:25 GMT
|
Viewed:
|
2816 times
|
| |
|
|
Hallo Dave!
Thanks for your respond.
I've done your suggestion. I connected two linux computers with a
nullmodem cable.
On the other computer nqc is working correctly, but it has installed an
older version of nqc 2.0.2 (on my notebook runs nqc 2.2., I hope, this
is no problem).
This is the output from my notebook (where nqc does not work correctly).
Here I started nqc fist on the notebook, then on the other computer:
spock:/var/log # nqc -v -raw 10
Tx: 55 ff 00 10 ef 10 ef
Rx: 78 0f 78 ff fc 00 00 00 f8 f8 78 00 c0 00 f8 f8 f8 78 0f 78 ff fc 00
00 00 f8 f8 78 00 c0 00 f8 f8 f8
Tx: 55 ff 00 10 ef 10 ef
Rx:
Problem talking to IR device
Here I started nqc fist on the other computer, then on my notebook:
spock:/var/log # nqc -v -raw 10
Tx: 55 ff 00 10 ef 10 ef
Rx: 78 0f 78 ff fc 00 00 00 f8 f8 78 00 c0 00 f8 f8 f8
Tx: 55 ff 00 10 ef 10 ef
Rx:
Problem talking to IR device
The other computer mostly did not receive anything from the notebook.
Sometimes on the first left rx field appeared a 72, nothing else.
I compared the setserial output for ttyS0 on both computers. Setserial
on the notebook pcmcia card recognized a UART 16950/954, setserial on
the other computer a 16550A. This was the only difference.
Regards.
Michael
|
|
Message has 1 Reply:
 | | Re: problems with nqc under linux
|
| It looks like the serial port just isn't getting the right settings (baud, parity, etc). I'm not sure how to go about diagnosing/fixing it...NQC makes some rather straightforward POSIX calls to configure the serial port. If it is not working, then (...) (23 years ago, 18-Aug-01, to lugnet.robotics.rcx.nqc)
|
Message is in Reply To:
| | problems with nqc under linux
|
| Hallo! Has anybody experiences with nqc for linux on notebooks? I want to use nqc under linux on a notebook computer. I use a serial pcmcia card from socket communications. The serial port is configured as ttyS0 (irq 4 and io-adr. 0x03f8 are (...) (23 years ago, 15-Aug-01, to lugnet.robotics.rcx.nqc)
|
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
