Subject:
|
Re: Firnware 2.0 and RCXCC
|
Newsgroups:
|
lugnet.robotics.rcx.nqc
|
Date:
|
Tue, 10 Jul 2001 01:32:37 GMT
|
Viewed:
|
2500 times
|
| |
|
|
Hi Rob,
You can get the original version of RCXCC to support the RCX2 firmware. The
main change is to add the following line to your autoexec.bat:
SET NQC_OPTIONS=-TRCX2
Of course, you also need the new firmware and a version of NQC that supports
it. This does not give you the syntax highlighting, etc., for all the new
language features.
Personally, I recommend that you try the RCXCC version created by John
Hansen. Not only does it support RCX2 features, it also adds many new
features. Perhaps most important of all, it is actively supported.
http://members.aol.com/johnbinder/rcxcc.htm
Enjoy,
Gus Jansson
|
|
Message is in Reply To:
 | | Firnware 2.0 and RCXCC
|
| Hi Everyone, Like the subject says, I am looking for some info on using the new firmware with RCXCC. Up until now, I have found the old version of NQC written by Mark Overmars to be more than enough for what I need. Just recently, though, I built a (...) (23 years ago, 9-Jul-01, to lugnet.robotics.rcx.nqc)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
