 | | Re: Electrical Data Link between 2 RCXs
|
|
(...) Hi Dean, meanwhile I followed your suggestions and implemented a scheme that uses a pulse scheme like this: ______ ______ ______ __ ______ ______ ___...___ Start Bit3 Bit2 Bit1 Bit0 A bit value of 1 results in a long pulse, a bit value of 0 in (...) (24 years ago, 3-Apr-01, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: Electrical Data Link between 2 RCXs
|
|
(...) My guess is that SENSOR_1 in your receiving RCX is getting a 1 when your program starts. I imagine that OFF is the default state for OUT_B in your transmitter RCX, and that the receiver is seeing this before OUT_B is switched to FLOAT. This is (...) (24 years ago, 3-Apr-01, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: Electrical Data Link between 2 RCXs
|
|
It's me again with some improvements for an "Electrical Data Link between 2 RCX". In the current version I changed the default condition of the link to "high" (in the transmitter: OFF(OUT_B)) so that the receiver has a 1 at its sensor input. So, you (...) (24 years ago, 17-Apr-01, to lugnet.robotics.rcx.nqc)
|
