To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.rcx.nqcOpen lugnet.robotics.rcx.nqc in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / RCX / NQC / 1026
1025  |  1027
Subject: 
Re: sending variables betwen rcx's?
Newsgroups: 
lugnet.robotics.rcx.nqc
Date: 
Tue, 13 Mar 2001 00:39:41 GMT
Viewed: 
2004 times
  
Mechanical responce to light stimuli, involving motor ports from the RCX to
controll levers ,switches or other motion components. A series of Send and
Recive, & Wait times, allow Comand stacks from the sensor watchers to to
activate these devices. Interaction or dialog beteen these light variables,
message managing and mechanical controll provide the answer, since each RCX
can react and start the its' own behavior. but then again, they only call me
the Legomaster. www.brickshelf.com/cgi-bin/gallery.cgi?f=2738 (shameless plug)



In lugnet.robotics.rcx.nqc, Adam Craggs writes:
to all

i am currently working on a robot with 2 rcx due to the number of sensors i
have on the robot.

my current problem is that i have 2 light sensor which is conected to
seperate rcx. one of the rcx with light sensor is calibrated using some
coloured card. i would like to know how i could send variables / values / a
datalog from 1 rcx to other.

i am currently using rcx2 firmware and have a knowlege of messages although
these canot solve the problem with this.

i looked into some of the low level serial codes 0x50 stop all task in the
documentation. there are many pages and i think there may be a solution
there but i dont understand how these documentation works. anyone help i
will be most gratefull as i am quite new to mindstorms and nqc and trying
this quite difficult project. many thanks.

thanks again...

from adam



Message is in Reply To:
  sending variables betwen rcx's?
 
to all i am currently working on a robot with 2 rcx due to the number of sensors i have on the robot. my current problem is that i have 2 light sensor which is conected to seperate rcx. one of the rcx with light sensor is calibrated using some (...) (24 years ago, 12-Mar-01, to lugnet.robotics.rcx.nqc)

5 Messages in This Thread:



Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR