 | | Re: Scout poweroff time out?
|
|
(...) Looking at the Scout SDK, I think it does support the same sleep time command as the RCX - although perhaps not from within a program. There are two things to try: nqc -sleep 0 or add the following function to your program and call it (with (...) (24 years ago, 30-Sep-00, to lugnet.robotics.rcx.nqc, lugnet.robotics.scout)
|
| |
| | Scout poweroff time out?
|
|
I've just finished a very cool Camera mount that can be controlled via the web. (Linux, NQC & PHP) I've decided to use my scout because it's so limited. I've noticed one point and can't seem to see away way around this. I'm hoping someone can help. (...) (24 years ago, 29-Sep-00, to lugnet.robotics.rcx.nqc, lugnet.robotics.scout)
|
| |
| | Re: NQC & Rotation Sensor
|
|
(...) Do you have the sensor at a place where one rotation of the sensor = 360 degrees of whatever you're turning? I'd suggest putting it somewhere where it rotates a lot more times than the actual turntable. (You need a touch sensor for 0 this way, (...) (24 years ago, 26-Sep-00, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: NQC & Rotation Sensor
|
|
(...) Dave, Thanks for the reply, I had a bad feeling it would be this way. If that wasn't bad enough it keeps losing 2 points when stepped from 0 to 16 and back again... Most annoying. I'm going to move to a touch sensor bump mode... This way my (...) (24 years ago, 26-Sep-00, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: NQC & Rotation Sensor
|
|
(...) The reset is a consequence of one of the bytecodes used to configure the sensor. I don't see a way to work around it. (...) This will have the same problem - in fact the generated code is probably identical (except for perhaps order) to just (...) (24 years ago, 26-Sep-00, to lugnet.robotics.rcx.nqc)
|
