|
|
 | | Re: direct manipulation of bits in RCX registers using NQC
|
| Hey, Thanks for all the helpful responses, everyone. Brian: (...) I guess that "firmware" must be the code that tells RCX how to interpret user instructions (NQC, C, IC, opcodes, or whatever), and convert them to binary machine-specific code. Right? (...) (19 years ago, 16-Sep-05, to lugnet.robotics.rcx.nqc)
| | | | | Re: direct manipulation of bits in RCX registers using NQC
|
| (...) I agree with Steve that the code samples you posted are probably BrickOS. Now to acheive what you want, it might be a waste of power, but you could always blank off the light itself with a peice of black card or thin black packing plastic. If (...) (19 years ago, 13-Sep-05, to lugnet.robotics.rcx.nqc)
| | | | | Re: direct manipulation of bits in RCX registers using NQC
|
| (...) Matt, There are a few ways you can program your RCX. The main choice is if you use the standard firmware, or not. The firmware is pretty much like Windows Operating System. If you use NQC & the standard firmware, you don't need to worry about (...) (19 years ago, 13-Sep-05, to lugnet.robotics.rcx.nqc)
| | | | | Re: direct manipulation of bits in RCX registers using NQC
|
| (...) inside the RCX *directly*, not running programs layered on top of the standard firmware. And if you want to use NQC, you have to work within the limits of the standard firmware (OK, ignoring Dick Swan's firmware, which I've still not been able (...) (19 years ago, 13-Sep-05, to lugnet.robotics.rcx.nqc)
| | | | | Re: direct manipulation of bits in RCX registers using NQC
|
| (...) Hi Brian, Thanks for your response. (...) I'm not sure if I get this, because of C code examples I've seen, which I'll discuss again below. (...) I've tried this already, and as you say, it works, but the sensitivity goes waay down. For a (...) (19 years ago, 13-Sep-05, to lugnet.robotics.rcx.nqc)
|
|
