To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.rcx.legosOpen lugnet.robotics.rcx.legos in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / RCX / legOS / 3783 (-5)
  Re: Kernel size
 
Hi Andreas, (...) It is about 22cm x 12cm for the two dimensional kernel. (couldn't resist) Actually, the size of the kernel is sort of unknown until you built it. It depends on your preferences and to some degree of the compiler version you build (...) (20 years ago, 29-Jul-04, to lugnet.robotics.rcx.legos)
 
  Kernel size
 
Hi, I've got a really small question. What's the size of the LegOS Kernel which you have to load on the RCX? Andreas (20 years ago, 29-Jul-04, to lugnet.robotics.rcx.legos)
 
  Re: Problem
 
Trent, Make sure the following files exist in the paths listed below (within the main BrickOS folder): boot\brickos.srec util\firmdl3.exe If those do not exist, then you need to run the configuration routine and MAKE to build the firmdl3 application (...) (20 years ago, 26-Jul-04, to lugnet.robotics.rcx.legos)
 
  Re: Problem
 
(...) You'd be up and running already without a hitch if you used my pre-built installers for cygwin & brickOS. Downloading the firmware using BricxCC is very simple as well. (URL) Hansen (20 years ago, 26-Jul-04, to lugnet.robotics.rcx.legos)
 
  Re: Problem
 
(...) Are you sure you typed "ln"? That should be "LN" but lowercase. It can be easy to confuse "l" with "i". ROSCO (20 years ago, 26-Jul-04, to lugnet.robotics.rcx.legos)


Next Page:  5 more | 10 more | 20 more

Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR