 | | Re: Problem —Andreas Jurk
|
| | | (...) Hi, try to use this command to install brickOs on your RCX: ./firmdl3 ../boot/brickos.srec Andreas (20 years ago, 26-Jul-04, to lugnet.robotics.rcx.legos)
|
| | | |
| | | | | Re: Problem —Trent Pendlebury
|
| | | | | (...) (20 years ago, 26-Jul-04, to lugnet.robotics.rcx.legos)
|
| | | | | |
| | | | | | | Re: Problem —Joseph Woolley
|
| | | | | | Trent, Make sure the following files exist in the paths listed below (within the main BrickOS folder): boot\brickos.srec util\firmdl3.exe If those do not exist, then you need to run the configuration routine and MAKE to build the firmdl3 application (...) (20 years ago, 26-Jul-04, to lugnet.robotics.rcx.legos)
|
| | | | | | |
| | | | | Re: Problem —John Hansen
|
| | | | (...) You'd be up and running already without a hitch if you used my pre-built installers for cygwin & brickOS. Downloading the firmware using BricxCC is very simple as well. (URL) Hansen (20 years ago, 26-Jul-04, to lugnet.robotics.rcx.legos)
|
| | | | |
