 | | Re: Parallel sensor problem —Bernardo Dal Seno
| | | | (...) I don't know if this is your problem, but the input ports have polarity (one lead is connected to ground and the other to +5V through a resistor, if I remember correctly). Have you tried to change polarities? (...) Maybe the problem is not in (...) (24 years ago, 23-Jan-01, to lugnet.robotics.rcx.legos)
| | | | | | | | | | Re: Parallel sensor problem —Ross Crawford
| | | | | Bernardo Dal Seno <piu1759@cdc8g5.cdc.polimi.it> wrote in message news:87d7dd25ge.fsf@...o.bogus... (...) crane, and (...) RCX 2. (...) like: (...) Thanks. I'll try that. (...) happens (...) connected to (...) Nup. I disconnected the motor, but the (...) (24 years ago, 24-Jan-01, to lugnet.robotics.rcx.legos)
| | | | | | | | | | | | Re: Parallel sensor problem —Ross Crawford
| | | | | (...) That isn't the problem. I reversed the sensor on one RCX, and they both showed it as being constantly pressed, so that must be the wrong polarity. But I also tried moving it from input 2 to 3. Works fine. Same programs, everything, it works in (...) (24 years ago, 24-Jan-01, to lugnet.robotics.rcx.legos)
| | | | | | |
