 | | Re: Question about mm.C in BrickOS
|
|
(...) Michael I was reading through your reply you sent me a while back and I don't understand what that line in the code does and you explaination of it. I don't understand what is meant by pointing behind the block. Any help would be great thanks. (...) (21 years ago, 14-Sep-03, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Setup sensor type using LegOS Commands Reference 1.0-0.2.4
|
|
There is a tutorial no ? nanobapt (...) (21 years ago, 14-Sep-03, to lugnet.robotics.rcx.legos)
|
| |
| | Setup sensor type using LegOS Commands Reference 1.0-0.2.4
|
|
Dear all, Can you please tell me how I can select a sensor type using the LegOS Commands Reference 1.0-0.2.4? Regards Alkis (21 years ago, 13-Sep-03, to lugnet.robotics.rcx.legos)
|
| |
| | Re: some measurements in lnp, please comment!
|
|
"Brian B. Alano" <alano@bloomington.in.us> wrote in message news:HL30D6.1rDC@lugnet.com... (...) practical (...) assume 50% (...) think anything (...) I'm not familiar with LNP, but I do have a good handle on infra-red messaging in general. There (...) (21 years ago, 12-Sep-03, to lugnet.robotics.rcx.legos)
|
| |
| | Re: some measurements in lnp, please comment!
|
|
(...) Old thread, but oh, well. 4800 baud is 4800 bits per second or 600 bytes per second. If you assume 50% overhead, which is optimistic, that's 300 bytes per second. So I think anything over 200 bytes per second is pretty good. (21 years ago, 12-Sep-03, to lugnet.robotics.rcx.legos)
|
