 | | Re: Blocking IR
|
|
(...) So I just tried this, and it took more than a few minutes to get it to work. But it does work. Apparently, the modulation of the IR signal is needed for the light sensor to give a reading. The standard modulation used during regular IR (...) (25 years ago, 20-Jun-99, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Blocking IR
|
|
(...) I doubt you have a broken RCX. If you did, firmdl.c would not download firmware correctly. (...) That is a good thing to try; I suppose it did not help things? (...) I don't see why you couldn't post the .srec file. I don't know if you also (...) (25 years ago, 20-Jun-99, to lugnet.robotics.rcx.legos)
|
| |
| | Re: legOS make newbe question
|
|
(...) Too bad nobody who actually uses LegOS is speaking up. I was under the impression you weren't supposed to move any makefiles around, and that you were just supposed to edit the appropriate makefile (probably Makefile.common) and type make at (...) (25 years ago, 20-Jun-99, to lugnet.robotics.rcx.legos)
|
| |
| | Re: legOS make newbe question
|
|
I've got it making the first-c++.o file now, but it chokes because it can't find the first-c++.coff file. Probably because it's not being made for some reason. Here is the current make message: snip-- C:\legOS.0.1.7>make h8300-hms-ld -T h8300.rcx (...) (25 years ago, 20-Jun-99, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Blocking IR
|
|
Thanks for your help but I think I might have a broken RCX. The code I've been testing and the examples you have help me with all work if I place the light sensor about 2 mm from the IR transmitter. At about 2cm it no longer works at all. I have (...) (25 years ago, 20-Jun-99, to lugnet.robotics.rcx.legos)
|
