|
|
 | | Re: firmdl question
|
| (...) I believe the units are tens of firmware bytes downloaded already. Oh, to point out the obvious, this is a ROM thing, not a firmdl thing. -Kekoa (25 years ago, 13-May-99, to lugnet.robotics.rcx.legos)
| | | | | Re: Rom sensor read routine
|
| (...) The current LegOS model really hammers the sensors, almost to the point of oversampling them. It only takes a short while (less than 0.1 ms, I think) to sample all four sensors; I think LegOS samples the next sensor immediately after finishing (...) (25 years ago, 13-May-99, to lugnet.robotics.rcx.legos)
| | | | | firmdl question
|
| When using firmdl to download a program to the RCX, what exactly do the numbers on the LCD indicate? Are there units I should be attaching to them, or are they just there to indicate progress without specific units? Just curious- Luis ###...### God (...) (25 years ago, 13-May-99, to lugnet.robotics.rcx.legos)
| | | | | Re: Rom sensor read routine
|
| Hi Kekoa, (...) I am fixing this right now. (...) The current legOS sensor read cycle is this (i=illuminate, c=A/D conversion) S1: iii iii iii ccc S2: ccc iii iii iii S3: iii ccc iii iii S4: iii iii ccc iii If you find your sensor 2 readings to be (...) (25 years ago, 2-May-99, to lugnet.robotics.rcx.legos)
| | | | | Re: Lego Network Protocol questions
|
| (...) I believe transmission and reception are independent, i.e. the emitter circuit is decoupled from the receiver circuit. The hardware on the H8 is full duplex. Once you finish sending a byte, I think you get two interrupts: one saying a byte has (...) (25 years ago, 5-May-99, to lugnet.robotics.rcx.legos, lugnet.robotics)
|
|
