Subject:
|
Re: MacNQC and RCX Troubles
|
Newsgroups:
|
lugnet.robotics.rcx
|
Date:
|
Fri, 29 Dec 2000 19:57:20 GMT
|
Viewed:
|
2005 times
|
| |
|
|
I haven't been able to download the firmware file as MacNQC isn't seeing the
file when I go to choose it for downloading, even though I can see the file
in the Finder. Does the firmware have to be loaded first before I can
successfully issue commands from the "test" panel and get a response from
the RCX? I haven't tried to download any programs yet. Thanks!
in article G6BKBA.M6I@lugnet.com, Monica Stewart at nica@appliedfantasy.net
wrote on 12/28/00 11:47 PM:
> There have been times I have been trying to download to my RCX ... and then
> I remember I haven't downloaded the firmware.
>
> Could this be you problem?
>
>
>
> In lugnet.robotics.rcx, Bob Pariury writes:
> > I just got RIS1.0 and can't seem to get the RCX to respond using MacNQC or
> > RCX Command Center running under Virtual PC 3.0. My cabling seems ok (using
> > Palm 3 mac serial port adapter) as the green light on the IR tower comes on
> > whenever I send a command. Am I missing something? Does the RCX need to be
> > in a certain mode for receiving? Please help!
|
|
Message is in Reply To:
 | | Re: MacNQC and RCX Troubles
|
| There have been times I have been trying to download to my RCX ... and then I remember I haven't downloaded the firmware. Could this be you problem? (...) (24 years ago, 29-Dec-00, to lugnet.robotics.rcx)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
