Subject:
|
RE: Help with connecting pyroelectric sensor
|
Newsgroups:
|
lugnet.robotics.rcx
|
Date:
|
Tue, 7 Sep 1999 19:10:51 GMT
|
Viewed:
|
1393 times
|
| |
|
|
Here's the link to the pyro sensor
<http://www.acroname.com/robotics/parts/R1-442-3.html>
The schematic indicates that the reference moves relative to the output...
I think the reference and output terminals are mislabelled. Given
that they are mislabelled...
The reference output has a 20uA max load, so forget using it
without a buffer. The output pin is buffered though an opamp
and has a minimum load requirement of 125K, so you SHOULD be able
to hook it right up to the RCX, with the signal routing diodes
and Rin and C for the power supply of course.
Comments Michael?
Cheers,
Ralph Hempel - P.Eng
--------------------------------------------------------
Check out pbFORTH for LEGO Mindstorms at:
<http://www.hempeldesigngroup.com/lego/pbFORTH>
--------------------------------------------------------
Reply to: rhempel at bmts dot com
--------------------------------------------------------
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
