 | | Re: Help needed: Problems setting up the IR tower —Reinis Kanders
|
| | | Check your BIOS settings to see if those ports are enabled, maybe instead of auto set them manually in BIOS. Maybe soft reset is not enough to reset the port, but I doubt it, just to check it, unplug your box for couple of seconds. "Federico (...) (24 years ago, 13-Jun-00, to lugnet.robotics.rcx)
|
| | | |
| | | | | Re: Help needed: Problems setting up the IR tower —Federico Hanssen
|
| | | | I have tried both Andi Scharfstein´s and Reinis Kanders´ recommendations and everything seems ok but there was no improvement... The comm port works fine with my PalmPilot craddle but not with my IR tower...Does anyone else have another (...) (24 years ago, 14-Jun-00, to lugnet.robotics.rcx)
|
| | | | |
| | | | | | Re: Help needed: Problems setting up the IR tower —Antonio Ianiero
|
| | | | (...) Have you already tried with a new 9V battery in the IR tower? Antonio (24 years ago, 14-Jun-00, to lugnet.robotics.rcx)
|
| | | | |
| | | | | | Re: Help needed: Problems setting up the IR tower —Federico Hanssen
|
| | | | Yes, I did but it didn´t work either... (...) (24 years ago, 16-Jun-00, to lugnet.robotics.rcx)
|
| | | | |
