Subject:
|
Re: Alternative Power Supplies
|
Newsgroups:
|
lugnet.robotics.rcx
|
Date:
|
Thu, 27 Apr 2000 18:46:17 GMT
|
Viewed:
|
1721 times
|
| |
|
|
Kurt Raschke wrote:
> I have an RIS 1.5 set, which doesn't have the power connector. I seem to
> run through a set of batteries in 1-2 weeks, which will eventually get very
> expensive. What ways are there, other than using rechargable batteries, to
> supply power to the RCX without the high cost of batteries?
>
> -Kurt
I'm actually working on a small device that will connect directly to the
battery posts in the RCX/Scout.
It uses a relay and a few diodes to protect the RCX from reverse polarity and
overload. The relay will allow you to switch from internal power to external
power without losing the firmware.
I don't as yet have it finished and can't provide any other information. But
watch my site...
Dean
--
Coin-Op's For Sale!: http://www.akasa.bc.ca/tfm/coin-op.html
Dean's Lego Workshop: http://www.akasa.bc.ca/tfm/lego_wr.html
Vancouver Lego Club: http://www.akasa.bc.ca/vlc
|
|
Message is in Reply To:
 | | Alternative Power Supplies
|
| I have an RIS 1.5 set, which doesn't have the power connector. I seem to run through a set of batteries in 1-2 weeks, which will eventually get very expensive. What ways are there, other than using rechargable batteries, to supply power to the RCX (...) (25 years ago, 26-Apr-00, to lugnet.robotics.rcx)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
