RCX programmable brick : 2574


Robotics / RCX / 2574	2573 \| 2575

Subject:	Re: sub-vi begin vs end control
Newsgroups:	lugnet.robotics.rcx.robolab, lugnet.robotics.rcx
Date:	Sun, 16 Jan 2005 21:00:51 GMT
Viewed:	2905 times

In lugnet.robotics.rcx.robolab, Elizabeth Mabrey wrote: > Hi, > > After a sub-vi is created, there are two controls created namely begin and > end. Would someone explain why they are backwards? That means, it creates > an "end" control linked to the beginning of the sub-vi, while the "begin" at > the end. It is a leftover from LabVIEW. When you create a sub.vi, LabVIEW reuses the name of whatever is wired to the control/indicator. This behavior makes perfect sense in LabVIEW but much less so in Robolab. FWIW, the names are little more than labels and you can change them as you see fit. Tom

Message has 1 Reply:

		RE: sub-vi begin vs end control
Hi Tom, Just for my education purpose, I'd like to understand the difference between the "begin" & "end" control boxes at the "Front Panel" window. Although they look identical, they must be different since they failed to wire to the blocks next to (...) (20 years ago, 16-Jan-05, to lugnet.robotics.rcx.robolab, lugnet.robotics.rcx)

Message is in Reply To:

		sub-vi begin vs end control
Hi, After a sub-vi is created, there are two controls created namely begin and end. Would someone explain why they are backwards? That means, it creates an "end" control linked to the beginning of the sub-vi, while the "begin" at the end. Thank in (...) (20 years ago, 16-Jan-05, to lugnet.robotics.rcx.robolab, lugnet.robotics.rcx)

5 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search