Subject:
|
Re: MOC: RCX mifig-scale wire-pulled train
|
Newsgroups:
|
lugnet.robotics.rcx
|
Date:
|
Wed, 16 Jun 2004 04:35:28 GMT
|
Viewed:
|
3664 times
|
| |
|
|
| |
Looks like inspiration to build a funicular (the same thing but intended to
go up and down hills). Of course, to do that (I’m always thinking in LTC
display mode) requires a hill to go with it.
|
That’s a good idea!! This would require two wagons for balancing: one going up
while the other is going down. Alas!! I will never have enough bricks to build
the hill!! :o(
| |
I didn’t see whether you had an active mechanism to maintain cable tension or
just did a very careful job setting the cable length?
|
No there is no mechanism to maintain the cable tension. I tought about it do,
and note it as a TO-DO to improve in the info.txt
The cable was just a pain to adjust but it works very fine. I also installed two
ruberbands in the wheels to increase the grip.
Thanks for your remarks,
Chris
|
|
Message is in Reply To:
 | | Re: MOC: RCX mifig-scale wire-pulled train
|
| (...) Chris- What a cool project! Looks like inspiration to build a funicular (the same thing but intended to go up and down hills). Of course, to do that (I'm always thinking in LTC display mode) requires a hill to go with it. I didn't see whether (...) (20 years ago, 14-Jun-04, to lugnet.robotics.rcx, FTX)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
