 | | Re: Multiplexing 4 touch sensors on an RCX input port
|
|
(...) Good analysis. Series can work quite well as long as you know that the touch sensors are touched mutually exclusively, but you are right parallel doesn't work well. I remember trying to come up with good resistance values to do parallel, and (...) (21 years ago, 9-Sep-03, to lugnet.robotics.rcx)
|
| |
| | Re: Multiplexing 4 touch sensors on an RCX input port
|
|
(...) While in theory, this sounds very cool, in pratice, I doubt it will work quite that well. The biggest problem will be that the standard touch sensors may not be 100% on when you press it. This means the sensor itself can provide some (...) (21 years ago, 9-Sep-03, to lugnet.robotics.rcx)
|
| |
| | Re: Multiplexing 4 touch sensors on an RCX input port
|
|
(...) I don't think that would work very well, as the lights have a rather low resistance, lower than a pressed touch sensor ((URL) as a purist you can use the cybermaster sensors to multiplex three inputs ((URL) Jürgen Stuber <stuber@loria.fr> (...) (21 years ago, 9-Sep-03, to lugnet.robotics.rcx)
|
| |
| | Re: Multiplexing 4 touch sensors on an RCX input port
|
|
(...) LEGO purists use LEGO light bricks as resistors. I created potentiometer bricks, where the resistance is variable for each brick. Two stacks of 4 potentiometer bricks can be seen to the left of the RCX. In this case each stack puts the (...) (21 years ago, 9-Sep-03, to lugnet.robotics.rcx)
|
| |
| | Multiplexing 4 touch sensors on an RCX input port
|
|
You can use four touch sensors per input port on the RCX. The Cybermaster touch sensors have resistors in parallel, and this is how the Cybermaster knows which implement is attached to the tracked robot. It uses its sensor input as a temperature (...) (21 years ago, 5-Sep-03, to lugnet.robotics.rcx)
|
