 | | RE: Turning the RCX off and on again (was: New pbForth 2.1.0 (and firmware speed))
|
|
I need to look at some items for Joerg, but I'll also look at a small supervisor that integrates the View,Run,Prgm,and On/Off buttons. This hsould be pretty easy and would be a good bit of example code. Cheers, Ralph (23 years ago, 11-Apr-02, to lugnet.robotics.rcx.pbforth, lugnet.robotics.rcx)
|
| |
| | Re: Turning the RCX off and on again (was: New pbForth 2.1.0 (and firmware speed))
|
|
(...) off (...) True. But I find not very practical to be forced to use the terminal to switch off the RCX or start the program again, expecially when you are attending a contest or take your robot to an exhibit. What I meant by "supervisor" is some (...) (23 years ago, 11-Apr-02, to lugnet.robotics.rcx.pbforth, lugnet.robotics.rcx)
|
| |
| | Two RCX with one IR-Tower
|
|
Hello, I want to control two RCX with one ir-tower. The problem is that the RCX should send back status information. Sending information to the RCX is quite easy: Both RCX receive the message but only one will perform the command. I found (...) (23 years ago, 11-Apr-02, to lugnet.robotics.rcx)
|
| |
| | Re: Turning the RCX off and on again (was: New pbForth 2.1.0 (and firmware speed))
|
|
(...) If you have the new version 2.1 the POWER-OFF word via terminal to shut off and the red button to power on works fine. If you have an earlier version (1.2x) you have to use the words RCX_INIT and POWER_INIT to initialize the brick and the (...) (23 years ago, 11-Apr-02, to lugnet.robotics.rcx.pbforth, lugnet.robotics.rcx)
|
| |
| | Turning the RCX off and on again (was: New pbForth 2.1.0 (and firmware speed))
|
|
Mario, i'm interested in pbForth example scripts, too. Furthermore, the "supervisor" you suggested could be the answer to one of my questions in (URL) concerning turning the RCX off and on without loosing pbForth: 2) According to Knudsen, i have to (...) (23 years ago, 11-Apr-02, to lugnet.robotics.rcx.pbforth, lugnet.robotics.rcx)
|
