 | | RCX infrared broken -- what now?
|
|
I recently dug my old MindStorms sets out of storage after about five years of inactivity. Naturally the RCXes (I have three) all needed to have their firmware re-installed. I was able to successfully refresh two of the bricks but not the third. I (...) (16 years ago, 20-Aug-08, to lugnet.robotics.rcx)
|
| |
| | Re: Problem to send long messages from RCX to PC via com Hack
|
|
(...) Dear Matthew I have found the problem. It was in kernel\lnp-locical.c -> cheking the echo was the problem solution: echo OFF it is a rough solution, but it works changes 1) rx_handler(void) ... // echos of own bytes -> collision detection // (...) (16 years ago, 29-Jun-08, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Problem to send long messages from RCX to PC via com Hack
|
|
I don't know if this is would be of any help, as it uses a different approach, but I thought I'd pass it along anyway.... Bi-directional Bluetooth to IR translator - (URL) (PDF format: (URL) ) While this solution doesn't allow both the serial and IR (...) (16 years ago, 28-Jun-08, to lugnet.robotics.rcx.legos)
|
| |
| | brickOS is slower than NQC for sending message
|
|
I tested two ways with brickOS and NQC, source as below, you will find the NQC can only send about 80 messages in 4s, brickOS can send all 255 messages, but need 20s, in other word, NQC needs 50ms for sending a message, or brickOS needs above 100ms (...) (16 years ago, 26-Jun-08, to lugnet.robotics.rcx)
|
| |
| | Problem to send long messages from RCX to PC via com Hack
|
|
Hi, Once again i am back about RCX and BT-Connection. Receiving messages from the PC via BT to the RCX is OK. But if I send messages from the RCX to the PC with 4800 Baud i get only 4 Bytes. So I go back to 2400 Baud, forget BT and make a serial (...) (16 years ago, 10-Jun-08, to lugnet.robotics.rcx.legos)
|
