 | | RE: multiplex 2 touch sensors on a single RCX port
|
|
Sorry, I don't mean the duration, not hysteresis. -----Original Message----- From: news-gateway@lugnet.com [mailto:news-gateway...ugnet.com] On Behalf Of Elizabeth Mabrey Sent: Monday, June 02, 2008 6:11 PM To: lugnet.robotics.rcx....lugnet.com (...) (16 years ago, 3-Jun-08, to lugnet.robotics.rcx.robolab)
|
| |
| | multiplex 2 touch sensors on a single RCX port
|
|
I have these 2 touch sensors multiplexing on the same input port. Their raw values are 47 and 39. I tried to set up 2 separate events, one for the range of 45 to 50 and another one for 35 to 40. However, the one for the lower feedback often set off (...) (16 years ago, 2-Jun-08, to lugnet.robotics.rcx.robolab)
|
| |
| | Re: Remote control RCX by mobile phone
|
|
Dear Zhengrong Zang I don't thing that this will be work because as far as i know mobile phone's using the irda protokoll like on the pc's to comunicate to mobilephones and other devices. The protokoll is the same: baud parity and stopbit but it (...) (16 years ago, 30-May-08, to lugnet.robotics.rcx)
|
| |
| | Re: RCX Serial Hardware Hack
|
|
Dear Claude (...) A: Thank you for finding the PDF. (...) A: I will check ( measure the Voltage on the IF LEDS) should be approx. 9V betweem LED and Transistor if everything is off. (...) A: Now i had success . It works. (...) I have allready done (...) (16 years ago, 29-May-08, to lugnet.robotics.rcx.legos)
|
| |
| | Re: RCX Serial Hardware Hack
|
|
Dear Matthew (...) A: Now it works with 4800 baud via bluetoothconnection . There was a couple of Problems. 1) At first i tried with the USB Tower but i coult only swith to 4800 bauds but there is no possibilty to change parity. 2) With the serial (...) (16 years ago, 29-May-08, to lugnet.robotics.rcx.legos)
|
