 | | Re: BrickOS motor port horrors
|
|
(...) [snip] (...) Mark, Thanks for shooting this so quickly. Kevin (21 years ago, 27-Oct-03, to lugnet.robotics.rcx.legos, lugnet.robotics.rcx.nqc)
|
| |
| | Re: BrickOS motor port horrors
|
|
(...) As we discussed in email, it appears to be the firmware downloader causing the problem. I just tried downloading BrickOS 0.2.6.10 with both NQC 2.5 a1 and BricxCC 3.3.6.2 and experienced growling motors. I then downloaded BrickOS using firmdl3 (...) (21 years ago, 27-Oct-03, to lugnet.robotics.rcx.legos, lugnet.robotics.rcx.nqc)
|
| |
| | Re: BrickOS motor port horrors
|
|
(...) Me too. Without any program loaded, it seems to do funny things with the motors. But once I get a program downloaded, it works fine. The only thing that I find freaky is the different values for light sensors. There's hex percentages and dec (...) (21 years ago, 27-Oct-03, to lugnet.robotics.rcx.legos, FTX)
|
| |
| | Re: BrickOS motor port horrors
|
|
(...) Rob, I've had the same problem with BrickOS. The installation I used came with BrickOS already built. I reloaded the RCX with LEGO firmware and all three motor ports worked fine. I concluded it was a BrickOS problem that I would wrestle with (...) (21 years ago, 26-Oct-03, to lugnet.robotics.rcx.legos)
|
| |
| | Re: IR Sensitivity - Was: 1.5/2.0 infrared problem
|
|
(...) Mine have been apart more often than I'd like, too! :-) (...) My guess would be mostly for increased communication speed. With the higher baud rate, the duration of the 2-byte Spybot/Manas packets is halved. This allows for fewer collisions (...) (21 years ago, 26-Oct-03, to lugnet.robotics.rcx)
|
