 | | Re: Problems with changing LNP_HOSTADDR
|
|
(...) With the default CONF_LNP_HOSTMASK (0xf0), the host adress is encoded in the higher 4 bits, so you should write #define CONF_LNP_HOSTADDR 0x10 Eric (22 years ago, 5-Jul-02, to lugnet.robotics.rcx.legos)
|
| |
| | Problems with changing LNP_HOSTADDR
|
|
Hi, since a few hours, I'm trying to give an RCX another LNP_HOSTADDR - so I changed the appropriate line in boot/config.h from #define CONF_LNP_HOSTADDR 0x00 //!< LNP host address to #define CONF_LNP_HOSTADDR 0x01 //!< LNP host address and compiled (...) (22 years ago, 5-Jul-02, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Displaying info while debugging
|
|
Hi Ralph, I mentionned a while ago (see msg #508) that I have a problem with SAVE-SYSTEM. Could it be the same problem? Could it related to the USB driver and that, while saving the system, there is no period of inactivity and the buffer gets full (...) (22 years ago, 4-Jul-02, to lugnet.robotics.rcx.pbforth)
|
| |
| | Re: Linux driver for USB tower
|
|
Hi, (...) Good point. The tar file can be found at (URL) (22 years ago, 2-Jul-02, to lugnet.robotics.rcx.nqc, lugnet.robotics.rcx.pbforth)
|
| |
| | Re: Displaying info while debugging
|
|
Here it is... : wait 15 0 timer_SET BEGIN 0 timer_GET 0= UNTIL ; I go with 0,15 seconds to be on the safe side; 0,10 seconds is too border line. So now, the first example becomes: : TEST 100 0 DO I CR . wait 7 1 0 MOTOR_SET LOOP 7 4 0 MOTOR_SET ; (...) (22 years ago, 3-Jul-02, to lugnet.robotics.rcx.pbforth)
|
