 | | Re: Communicatin between NQC and legOS
|
|
(...) you won't be able to use LNP - those packets are completely different from the Lego firmware ones. You'll need to write bytes directly to the serial port (I'm not sure what support there is for this in legOS since once you start munging the (...) (24 years ago, 27-Sep-00, to lugnet.robotics.rcx)
|
| |
| | Re: NQC & Rotation Sensor
|
|
(...) Do you have the sensor at a place where one rotation of the sensor = 360 degrees of whatever you're turning? I'd suggest putting it somewhere where it rotates a lot more times than the actual turntable. (You need a touch sensor for 0 this way, (...) (24 years ago, 26-Sep-00, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: Communicatin between NQC and legOS
|
|
(...) OK, but do i have to create this frame using legos ?? I tried but it doesn't work. (thank you so far dave baum ! I received your book today, hope this will help me.) (24 years ago, 26-Sep-00, to lugnet.robotics.rcx)
|
| |
| | Re: NQC & Rotation Sensor
|
|
(...) Dave, Thanks for the reply, I had a bad feeling it would be this way. If that wasn't bad enough it keeps losing 2 points when stepped from 0 to 16 and back again... Most annoying. I'm going to move to a touch sensor bump mode... This way my (...) (24 years ago, 26-Sep-00, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: NQC & Rotation Sensor
|
|
(...) The reset is a consequence of one of the bytecodes used to configure the sensor. I don't see a way to work around it. (...) This will have the same problem - in fact the generated code is probably identical (except for perhaps order) to just (...) (24 years ago, 26-Sep-00, to lugnet.robotics.rcx.nqc)
|
