|
In lugnet.robotics, Philippe Hurbain wrote:
> In lugnet.robotics, Patrick J. Levy wrote:
> > It worked.
> >
> > The key was to save a file with .nxc extension...
>
>
> Agreed, even if you select NXT target BricxCC insists to use .nqc as default
> extension. Misleading at best...
In the soon to be available new test release, BricxCC (3.3.7.17) now properly
assumes NXC when a file has no extension if you switch your Preferred language
for the standard firmware (on the Compiler|Common tab of the Preferences dialog)
to be NXC. It also now assumes NXC when a file has no extension if the
Preferred language for the standard firmware is set to NQC and your brick type
is set to NXT.
My apologies for allowing BricxCC to mislead at its best.
John Hansen
|
|
Message has 1 Reply:
Message is in Reply To:
11 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
Active threads in...
Robotics
NXT programmable brick
|
|
|
|