|
|
 | | Re: Two NXT Back2Back
|
| (...) ReHi, I'm building an external SD-Card-Interface for storing data, using RS485... NXT-->RS485-->AtMega...->SPI-->SD Next project is AVRCAM via RS485 :D Thanks for your response Bye Christian (17 years ago, 7-Aug-07, to lugnet.robotics.nxt)
| | | | | multiple-files projects in NBC
|
| I might have missed this topic in the manual, but is there any support for splitting NBC project into several files? I know there is #include macro, but the problem is that the compiler then reports errors/warnings at lines relative to the merged (...) (17 years ago, 7-Aug-07, to lugnet.robotics.nxt)
| | | | | Re: Two NXT Back2Back
|
| (...) I do not see how you could burn any parts or drivers. Even if both ports would be in active sensor mode and (obviously) out-of sync, the electronics that connects the port to ADC should handle that as normally the same pin is used to power up (...) (17 years ago, 7-Aug-07, to lugnet.robotics.nxt)
| | | | | Re: NXT memory map
|
| (...) I found everything here (URL) not directly at Atmel... Christian (17 years ago, 7-Aug-07, to lugnet.robotics.nxt.nxthacking)
| | | | | Re: RotateMotorEx hangs
|
| (...) The change I have made is to replace this: // Waits till angle reached index __rotate_firstPort0, __rotate_ports0, NA __rotate_Running0: getout __rotate_rs0, __rotate_firstPort0, RunState brcmp EQ, __rotate_Running0, __rotate_rs0, (...) (17 years ago, 6-Aug-07, to lugnet.robotics.nxt)
|
|
