|
|
 | | Re: compilation switch in BrickCC Command Center?
|
| (...) Are you talking about defining a macro via a command-line switch such as nqc -Susb -d -DMYVAL=xyz foobar.nqc or something of that sort? If that is what you have in mind then you can do it from within BricxCC with NQC but I have not yet (...) (19 years ago, 6-Feb-07, to lugnet.robotics.nxt, lugnet.robotics)
| | | | | compilation switch in BrickCC Command Center?
|
| Thru brickcc command center, I wonder how to insert a user-defined compilation switch as I want to use it in the preprocessor directives. Input is greatly appreciated. --Elizabeth (19 years ago, 6-Feb-07, to lugnet.robotics.nxt, lugnet.robotics)
| | | | | Re: HELP! NXT brick flash now read-only!!
|
| (...) Juergen et al., Good news, everyone! The nightmare is over. :-) And I got to learn a few things in the process, too! Setting the security bit must have been what I did, although I don't specifically recall it...I do remember that, before I (...) (19 years ago, 5-Feb-07, to lugnet.robotics, lugnet.robotics.nxt)
| | | | | RE: HELP! NXT brick flash now read-only!!
|
| (...) It may be obvious, but: Holding the reset pin for a few seconds simply does a brick reset. Holding the reset pin for around 15 seconds is supposed to put the brick into SAMBA mode. You are doing the second I hope. And just to be safe, you've (...) (19 years ago, 4-Feb-07, to lugnet.robotics, lugnet.robotics.nxt)
| | | | | Re: HELP! NXT brick flash now read-only!!
|
| (...) OK, everybody take a deep breath and slow down. first of all, the SAMBA version I'm using is 1.11, available here: (URL) And for anyone that's going to get busy hacking firmware, this is a great place to start: (URL) Yes, there is a script (...) (19 years ago, 4-Feb-07, to lugnet.robotics, lugnet.robotics.nxt)
|
|
