 | | The LEGO Didn't Break (or the HALE Mission - LEGO where it was never intended to go)
|
|
OK, I'm a little bit proud of this... and, mostly, amazed that it functioned at all. I was selected to participate in the HALE (High Altitude LEGO Extravaganza) after submitted two proposals in the hopes one would make it... and instead, both were (...) (16 years ago, 30-Jul-08, to lugnet.robotics, lugnet.robotics.nxt, lugnet.technic) !
|
| |
| | Re: NXT-G Models in Vista
|
|
(...) Our tech had to take out the Adobe CS3 suite. Now the models show up. But CMU's Robotics Engineering does not. He reports that the old 'NXT clicking" version 1.0 was compatible with Adobe CS3. Seems Lego Tech Support has heard of something (...) (16 years ago, 26-Jul-08, to lugnet.robotics.nxt)
|
| |
| | NXT-G Models in Vista
|
|
I'm teaching this week using laptops running on Vista. The laptops also have the full suite of Adobe software. Under these conditions, the models do not show up. The models momentarily blink onto the screen, then the display goes blank. I suspect (...) (16 years ago, 24-Jul-08, to lugnet.robotics.nxt)
|
| |
| | Re: ONLINE LEGO NXT INTERFACING WORKSHOP
|
|
(...) Do you have any more information on this? It sounds interesting - and I love the HT Prototype board, I'm using it in my HALE mission to run far more sensors and even a heater circuit than I could have otherwise (& I'm lousy at electronics - (...) (16 years ago, 15-Jul-08, to lugnet.robotics.nxt)
|
| |
| | ONLINE LEGO NXT INTERFACING WORKSHOP
|
|
Hi All, I'm in the planning stages for having the first Online LEGO NXT Interfacing Workshop. The hands-on event will be conducted using Skype as participants will be learning the basics of electronics interfacing aided by Hi Technic's Prototype (...) (16 years ago, 15-Jul-08, to lugnet.robotics.nxt)
|
