To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 87
86  |  88
Subject: 
Re: My handyboard does not run.....
Newsgroups: 
lugnet.robotics.handyboard
Date: 
Wed, 21 Feb 1996 04:17:48 GMT
Original-From: 
gleason@AVOIDSPAMtiac.net
Viewed: 
3924 times
  
Dear Mr. Inouye,

I am disappointed to hear that your out-of-the-box experience with the
Handy Board was not a perfect one. Your board passed all tests, and I
believe that Fred's suggestions will solve the dlm difficulty. Please let
me know if they do not; it is my primary interest that you be happy with
your Handy Board purchase and I will do everything that I can to make it
so.

Best Regards,

Wanda Gleason


P.S. "Master of HB!"


------------------
Gleason Research -
Handy Boards
P.O. Box 1247
Arlington MA 02174-0021
phone/fax: 617-641-2551

gleason@tiac.net
http://www.tiac.net/users/gleason/handy-board
---------------------------------------------


> Dear Master of HB,
> 
> I bought a handy board made by Gleason Research (complete set), and
> connect RS232C cable to my PC. After I put the board into download mode,
> I put the command "a:> dlm pcode_hb." However, I found the following
> message on the screen and I could not see anything but blank characters
> on the LCD of the board.
> 
> I'd really appreciate if you let me know how to debug and fix this
> problem.
> 
> Best regards,
> 
> Kazuyoshi Inoue
> 
> ************** messges **************
> 
> Downloading eeprom loader to RAM at 1200baud.....
> .....
> .....
> -----
> 
> 512 total bytes (boot loader done)
> Synchronizing with board...ok
> Sending pcode_hb.s19 at 9600 baud
> Board memory error: wanted 00, got 3e at address 8000
> Board synchronization error.



Message has 1 Reply:
  Re: My handyboard does not run.....
 
Dear Mr. Gleason, I gave up to download pcode from my PC (Dell Dimension XPS133c), and I tried to connect the board to Macinctosh (LC475). Then, I could download pcode and the board run well. As Fred's suggestion, the problem was not your board but (...) (31 years ago, 21-Feb-96, to lugnet.robotics.handyboard)

2 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR